Hey All,
I am having a problem with an SBS2011 install. Everything has been fine for about a week but now several MMC's fail to load. I am working on those and they are not the most important issue just now. Here we go:
When the MMC's were working, I was able to load EMC, as well as Exchange PowerShell prompt. I now cannot. When I could, I set SmartHost settings which are no longer valid. The Receive Connecter is locked down to only receive from the SmartHost IP ranges, and the Send Connector has the Smart Host set. This is preventing email flow to both directions.
I can load Powershell and add the exchange powershell cmdlets. Can anyone provide the commands required to remove the settings mentioned above? (receive connector lock downs and send connectors smart host settings).
The overall issue as revealed by Exchange Management Console is:
"The Following error occurred while searching for the on-premises Exchange Server:
Connecting to the remote server failed with the following error message: The Client cannot connect to the destination specified in the request. verify that the service on the destination is running and accepting requests."
When I run "winrm qc" I receive:
"WinRM already is set up to receive requests on this machine.
WSManFault
Message = The WinRM client cannot complete the operation within the time spe
cified. Check if the machine name is valid and is reachable over the network and
firewall exception for Windows Remote Management service is enabled.
Error number: -2144108250 0x80338126
The WinRM client cannot complete the operation within the time specified. Check
if the machine name is valid and is reachable over the network and firewall exce
ption for Windows Remote Management service is enabled."
Please help :-(